4 - 2 - 2 Collective operation setting
•A collective operation setting and a collective prohibit setting can be performed for all the group managed by this controller at one time.
(1)Collective operation setting
1 Press the switch to set "COL. (COLLECTIVE)" in blinking
display and press the ENTER switch on the group operation setting screen.
2 The collective operation setting initial screen is displayed.
3 Select the items for operation setting on the collective operation setting initial screen.
The operation method is same as described in section
NOTE: The items which were not set, remain set to the same condition that were set before the collective operation was
performed.
4 The items selected for the operation blink on the collective operation setting screen.
5 When all setting are completed, press the switch to display the "SET" in blinking display for the indicated function area.
6 Press the ENTER switch one time to complete this setting.
The collective setting is executed.
The collective setting takes approximately 20 seconds.
NOTE: The display of setting contents is erased
when shift to another screen.
The collective setting is completed when the previous items light. (After the setting are completed, start from step 3 to perform operation again if change operation are required.)