GE RN328, JV338, JN327, JV348 For 31⁄4″ X 10″ Rectangular, For RECESSED-BOTTOM Cabinets Only

Page 11

Installation Instructions

8FOR 31⁄4″ X 10″ RECTANGULAR

DUCTED DISCHARGE INSTALLATIONS

ONLY:

Attach exhaust adaptor/damper over the appropriate knockout opening (for vertical or horizontal, depending on installation) with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back edge of hood. Remove tape from damper flap.

 

Exhaust adaptor/damper

 

Up to 1″ side-to-

(vertical discharge position)

Tape

side adjustment

 

 

Pivot

Top/back edge

(depending on

installation)Exhaust adaptor/damper (horizontal discharge position)

NOTE: The exhaust adaptor/damper can be installed up to 1″ on either side of the hood center to accommodate off-center ductwork. In extreme off- center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

9FOR 7″ ROUND VERTICAL DUCTED

DISCHARGE INSTALLATIONS ONLY:

Bend up the duct alignment ears in preparation for later attachment of the 7″ duct.

Attachment ear tabs

10FOR RECESSED-BOTTOM CABINETS

ONLY

Wood shims

(minimum thickness 3/8″)

•If the cabinets have front, side or back trim, make 2 wood shims a minimum of 3/8″ thick and cut to fit the width of the inner recessed cabinet bottom. Attach them to the cabinet bottom recess on both sides. See Step 11 for marking locations.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents You can find them on a label on the back wall of the hood Range HoodsDucted fans must always be vented to the outdoors This unit must be groundedUse an extinguisher only if ’UTILISEZ UN Extincteur que si Le fabricantCet appareil doit être bien mis à la terre Turn to on while cooking or to Nite for use as Night light That create a frequent need for cleaningPress the pad at the top to turn the light on Continuous use of the fan system while cookingLift the light cover and slide it toward you in one motion Remove the bulb and replace it withElbows, transitions, wall and roofcaps, etc Ductwork RequirementsExhaust connection Maximum duct lengthWORKSHEET-CALCULATE Total Equivalent Ductwork Length Installation InstructionsParts Included Damage SHIPMENT/INSTALLATIONMounting Space Tools YOU will NeedRecirculating Choose Vent OptionOutside top exhaust Outside rear exhaustRemove Filter Remove Wiring CoverRemove Wiring Knockout Remove Exhaust AdaptorFor RECESSED-BOTTOM Cabinets Only For 7″ Round Vertical Ducted Discharge Installations onlyFor 31⁄4″ X 10″ Rectangular OnlyCUT Holes RUN WiresMark Holes Secure Hood Optional Power Cord KIT JXHC1Feed in Wires Screw in Part WAYTroubleshooting Checklist Install Light BulbConnect Wiring Replace Wiring CoverGE Range Hood Warranty By phone at 800.626.2002 during normal business hours Schedule Service
Related manuals
Manual 16 pages 42.5 Kb
Top Page Image Contents