GE JN327, JV338 Screw in Part WAY, Optional Power Cord KIT JXHC1, Feed in Wires, Secure Hood

Installation Instructions

14SCREW IN PART WAY

Drive a mounting screw (from the hardware packet) part way into each center of the narrow neck of the keyhole slots marked on the cabinet bottom.

15OPTIONAL POWER CORD KIT JXHC1

An optional Power Cord Connection Kit, model JXHC1, is available at extra cost from your GE supplier for installation using a standard 3-prong, grounded wall outlet . Follow the Installation Instructions packed with the kit to connect the power cord to the range hood.

C

LCabinet

		3-prong
73⁄4″		wall outlet
	11⁄4″	(if using cord
		connection)

13⁄4″ dia. clearance hole for optional power supply location

NOTE: If using optional Power Cord Kit JXHC1, feed the power cord through the hole in the top cabinet while raising the hood. Loop any excess length of cord and tie away with a suitable tape

or tie.

16FEED IN WIRES

Lift the hood into position and feed the house wiring through the wiring knockout .

17SECURE HOOD

Slide the hood back against the wall. Tighten the mounting screws. Be sure the screw heads are in the narrow neck of the keyhole slot .

Mounting

screw (4)

Keyhole (4)

NOTE: DO NOT PUSH ON THE FAN BLADE. Pushing on the blade may cause it to interfere with other hood parts.

18CONNECT DUCTWORK TO HOOD

(Ducted installations only)

On 7″ round installations, attach the 7″ duct with sheet metal screws through the holes in the alignment ears.

7″ round duct

Attachment ear tabs

Use duct tape to make joints secure and air tight .

Duct tape

13