Electrolux 3A manual Prior to using for the first time, Adjusting the Water Softener, Special salt

Operating Instructions

Prior to using for the first time

Prior to using for the first time, remove all the clips with which the baskets are secured for transport.

Then perform the following steps: 0 1. Adjust the water softener

2.Fill with Salt for the Water Softener

3.Fill with Rinse Aid

Adjusting the Water Softener

	To prevent the build up of scale on dishes and in the dishwasher, the
	dishes must be washed with soft, i.e. low lime content water. For this
	reason the dishwasher is fitted with a water softener in which tap
	water from a hardness of 4 °d (German degree) is softened with the aid
	of special salt.
3	Your local water authority can advise you on the hardness of the water
	in your area.

0Adjust the water softener as stated in the table to the setting that cor- responds to the hardness of the water in your area. The water softener can be set manually using the water hardness switch and also electron- ically using the buttons on the control panel.

	Water Hardness			Hardness Setting		Display in the
in °d1)		in ppm2)	Range	Manual	Electronic	Multi-display
51 - 70		9,0 - 12,5			9	H 9
43 - 50		7,6 - 8,9			8	H 8
37 - 42		6,5 - 7,5	IV	1	7	H 7
29 - 36		5,1 - 6,4			6	H 6
23 - 28		4,0 - 5,0			5	H 5
19 - 22		3,3 - 3,9	III		4	H 4
15 - 18		2,6 - 3,2			3*	H 3
11 - 14		1,9 - 2,5	II	0*	2	H 2
4 - 10		0,7 - 1,8	I/II		1	H 1
					0
under 4		under 0.7	I		no salt	H 0
					necessary

10