Electrolux 3A manual Filling with Salt for the Water Softener, Fill with dishwasher salt

Page 12

Operating Instructions

Filling with Salt for the Water Softener

1

Use only salt designed for dishwashers. Never fill the salt container

 

with any another type of salt (e.g. culinary salt) or dishwasher deter-

gent as this would irreparably damage the water softener.

Prior to filling with salt, please check each time that you really do have a packet of dishwasher salt in your hand.

Fill with dishwasher salt:

Prior to using the dishwasher for the first time

When the SALT indicator J on the control panel is illuminated.

3

If the water hardness in your area is less than 4 °d, you do not need to

 

use dishwasher salt. The SALT indicator J on the control panel will

 

remain illuminated.

 

 

0 1.

Open the door, remove the lower

 

 

 

 

 

 

 

rack.

SALE

 

 

 

 

 

 

 

 

 

 

 

 

 

2.

Undo the lid on the salt container by

SALT

 

 

 

 

SALZ

 

 

 

 

 

turning it anticlockwise.

SEL

 

 

 

 

3.When using for the first time: fill the salt container with water.

4.Place the funnel supplied on the con-

tainer opening.

Fill the container with salt through

the funnel; the capacity of the con- tainer is approx. 1.0-1.5 kg depend- ing on the grain size. Do not overfill

the salt container with salt.

3

The water expelled by filling the salt container with salt runs out of the

 

salt container onto the base of the washing compartment. This is not a

cause for concern, the water will be pumped out at the start of the next wash programme.

5.Clean any salt remnants on the container opening.

6.Turn the lid clockwise to the stop, otherwise dishwasher salt will leak into the wash water, this could lead to poor wash results. To avoid this run a rinse programme after filling the salt container with special salt. This will wash away salt water and any salt crystals that have been spilt.

3

Depending on the size of the salt grains, it can take several hours for

 

the salt to dissolve in the water and the special salt indicator J to

extinguish. The setting of the water softener and the consumption of salt are dependent on the hardness of the local water.

12

Image 12
Contents Favorit 3A Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifSafety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displayPrior to using for the first time Adjusting the Water SoftenerSpecial salt Your areaElectronic adjustment Filling with Salt for the Water Softener Fill with dishwasher saltRemain illuminated Open the door, remove the lower Rack Turning it anticlockwiseSwitching Rinse Aid Supply On and Off Rinse AidThere are two ways to add rinse aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Loading Pans, Frying Pans Large Plates Load large and heavily soiled dishes in the lower basketFolded over to the left To ease the loading of large itemsFolded across one another Across one anotherTwo rear plate inserts in the lower Baskets can be folded across one anotherLoading Cups, Glasses and Coffee Services Adjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentGeneral Advice Special AdviceUse of 3 in 1/ Combi Detergent Tablets Concentrated Detergent Detergent tabletsSelecting the Wash Programme Programme Table SoilingChanging/Interrupting/Cancelling Start the Wash ProgrammeWash Programme Changing the wash programmeSetting or Changing the Delay Start Timer Cancelling the wash programmeSetting the delay start timer Changing the delay startCare and Cleaning Switching Off the DishwasherEmptying the Dishwasher Cleaning the Filter StancesError messages What to do, ifThere are problems with the operation of the dish- washer Wash results are not satisfactoryDishes are still dirty Dishes are wet and dullTechnical Data Lower rinse aid dosingThere are dried water drops on the glasses and dishes Sample loading arrangements Upper basket Lower basket with cutlery basketInstalling the Dishwasher See enclosed installation instructionsBuilt-Under Dishwasher Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG