Electrolux 3A manual Start the Wash Programme, Changing/Interrupting/Cancelling

Page 26

Operating Instructions

Start the Wash Programme

0 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate.

2.Open the tap fully.

3.Shut the door.

4.Press the ON/OFF button. The ON/OFF button indicator illuminates.

5.Press the programme button for the desired programme (see "Pro- gramme Table"). The programme indicator illuminates. The selected programme begins after around 6 seconds. The time remaining until the end of the programme is displayed on the multi-display, the time calculated is dependent on the load in the baskets.

With automatic programme adjustment this residual time count can be stopped or corrected if necessary (load quantity, degree of dirtiness, etc.) using the dishwasher control.

3	If fault messages are displayed on the multi-display after the start of
	the programme, please read the "What to do, if..." section.
	Changing/Interrupting/Cancelling
	the Wash Programme
3	Only change or interrupt a wash programme in progress if it is abso-
	lutely necessary to do so.
	Changing the wash programme
3	If you want to change the wash programme within 6 seconds of mak-
	ing a programme selection, briefly press the button for the new wash
	programme.
	If you want to change the wash programme at a later point in time, use
	the following procedure:

0 1. Press the button for the new wash programme and hold it pressed. The indicators for both programmes now flash.

2.After a few seconds only the indicator for the new programme flashes. Release the programme button, the new programme is now running.

Interrupting the wash programme by opening the door of the dishwasher

1Hot steam may escape from the appliance when opening the door. Open the door carefully.

26

Image 26

Contents Favorit 3A Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifChild Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displaySpecial salt Prior to using for the first timeAdjusting the Water Softener Your areaElectronic adjustment Remain illuminated Open the door, remove the lower Rack Filling with Salt for the Water SoftenerFill with dishwasher salt Turning it anticlockwiseThere are two ways to add rinse aid Switching Rinse Aid Supply On and OffRinse Aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Folded over to the left Loading Pans, Frying Pans Large PlatesLoad large and heavily soiled dishes in the lower basket To ease the loading of large itemsTwo rear plate inserts in the lower Folded across one anotherAcross one another Baskets can be folded across one anotherLoading Cups, Glasses and Coffee Services Raising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Filling with Detergent Fill with detergentUse of 3 in 1/ Combi Detergent Tablets General AdviceSpecial Advice Concentrated Detergent Detergent tabletsSelecting the Wash Programme Programme Table SoilingWash Programme Changing/Interrupting/CancellingStart the Wash Programme Changing the wash programmeSetting the delay start timer Setting or Changing the Delay Start TimerCancelling the wash programme Changing the delay startEmptying the Dishwasher Care and CleaningSwitching Off the Dishwasher Cleaning the Filter StancesError messages What to do, ifDishes are still dirty There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are wet and dullThere are dried water drops on the glasses and dishes Technical DataLower rinse aid dosing Sample loading arrangements Upper basket Lower basket with cutlery basketBuilt-Under Dishwasher Installing the DishwasherSee enclosed installation instructions Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedPermitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG