Electrolux 3A manual What to do, if, Error messages

Page 30

Operating Instructions

What to do, if ...

Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.

...Error messages

If the programme indicator for the selected wash programme is flashing and fault code (1 or (2 is displayed on the multi-display, you can probably rectify the fault yourself.

After rectifying this fault, press the button for the wash programme that has been started. The wash programme continues. If the fault code is displayed again, contact customer service.

For all other faults, please contact customer service, stating the fault code.

Symptom

Possible Cause

Solution

Fault code (1 is dis-

Tap is blocked or furred with

Clean tap.

played on the multi-

lime-scale.

 

display.

The filter (where present) in

 

The programme indica-

Clean the filter in the

tor for the selected

the threaded hose fitting is

threaded hose fitting.

blocked.

wash programme is

 

 

 

flashing:

 

 

there is no water run-

The water inlet hose is not

Check hose installation.

ning into the dish-

correctly laid.

 

washer.

 

 

Fault code (2 is dis-

The sink outlet is blocked.

Clean the sink outlet.

played on the multi-

 

 

display.

 

 

The programme indica-

The water drain hose is not

Check hose installation.

tor for the selected

correctly laid.

wash programme is

 

 

 

flashing.

 

 

Fault code (3 is dis-

The leak prevention system

Close the tap and contact

played on the multi-

your local AEG Sevice Force

has been triggered.

display.

Centre.

 

 

 

 

30

Image 30
Contents Favorit 3A Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifChild Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displaySpecial salt Prior to using for the first timeAdjusting the Water Softener Your areaElectronic adjustment Remain illuminated Open the door, remove the lower Rack Filling with Salt for the Water SoftenerFill with dishwasher salt Turning it anticlockwiseSwitching Rinse Aid Supply On and Off Rinse AidThere are two ways to add rinse aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Folded over to the left Loading Pans, Frying Pans Large PlatesLoad large and heavily soiled dishes in the lower basket To ease the loading of large itemsTwo rear plate inserts in the lower Folded across one anotherAcross one another Baskets can be folded across one anotherLoading Cups, Glasses and Coffee Services Adjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentGeneral Advice Special AdviceUse of 3 in 1/ Combi Detergent Tablets Concentrated Detergent Detergent tabletsSelecting the Wash Programme Programme Table SoilingWash Programme Changing/Interrupting/CancellingStart the Wash Programme Changing the wash programmeSetting the delay start timer Setting or Changing the Delay Start TimerCancelling the wash programme Changing the delay startCare and Cleaning Switching Off the DishwasherEmptying the Dishwasher Cleaning the Filter StancesError messages What to do, ifDishes are still dirty There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are wet and dullTechnical Data Lower rinse aid dosingThere are dried water drops on the glasses and dishes Sample loading arrangements Upper basket Lower basket with cutlery basketBuilt-Under Dishwasher Installing the DishwasherSee enclosed installation instructions Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedPermitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG