Electrolux Ventilation Hood manual To Level the Cooker Hood

Page 15

To Level the Cooker Hood

1.Remove the lower grille by pressing inwardly on the two slide catches located towards either side of the grille towards the front. The grille will open from the front.

2.Slide the right edge of the grille forward until it clears the guide and then unhook the left hinge pin.

3.Support the grille when removing it from the guides carefully.

4.The two levelling screws will be visible towards either end of the back panel.

5.Turn the screws clockwise to lift the front edge of the hood and use a spirit level to check the hood is positioned at right angles to the wall before fitting the security system.

6.The wall brackets have two studs and when the cooker hood is hung onto the brackets the studs project through the holes above the levelling screws.

7.When the hood is level fit the two shake proof washers and nuts supplied to fully secure the cooker hood.

Image 15

Contents Cod 03 Instruction BookElectrical Connections Maintenance and CleaningInstalling the Cooker Hood Service Force CentresMaintenance and Service Important Safety InformationInstallation Child SafetyIt will not extract steam Your Appliance Operating InstructionsControls To OperateExtraction RecirculationTo Remove/Replace the Charcoal Filter Maintenance and CleaningExternal Cleaning Charcoal FilterSynthetic Paper Grease Filter To Replace the Synthetic Paper Grease FilterChanging the Light Bulb Service and Spare Parts Symptom SolutionSomething not Working Guarantee Conditions France Senlis +33Germany Nurnberg +49 Electrical Connection Installation InstructionsElectrical Connections Electrical RequirementsPositioning Installing the Cooker HoodInstallation Requirements DuctingClearance Heights Unpacking Wall FittingVenting To Fit the Ducting To Remove the Charcoal FilterWall Cabinet Fitting To Level the Cooker Hood Page Page Page Page Electrolux Household Appliances Limited 55 77 High Street Slough