Electrolux TINSEB484MRR0 Installation Hardware, Preparation of the Oven, Name Quantity, Plate

Installation Instructions

6 INSTALLATION HARDWARE

The INSTALLATION HARDWARE items 1 - 7 are in a small bag. Items 8 - " are packed separately. All items are in a small carton packed below the oven.

Item	Name	Quantity
1	Wood Screw 5 x 30 mm	6*
2	Toggle Bolt with nuts #10 - 24 x 50 mm	4**
3	Top Cabinet Screw 5 x 60 mm	1
4	Top Cabinet Screw 5 x 60 mm	1
5	Tapping Screw 4 x 12 mm	8
6	Flat Washer 30 mm diameter	2
7	Grommet	1
8	Rear Cushion	1
9	Exhaust Damper Assembly	1
!	Scale Plate Spacer	2
"	Grease Filter	2

*Must use two - may use remaining four.

**May not use all - depending on stud location.

Parts shown not to common scale.

Figure 4

7 PREPARATION OF THE OVEN

1.Turn oven on the side. See Figure 5.

2.Follow steps (A)-(D) to remove mounting plate from the back of the oven as shown in Figure 5.

(A)Release mounting plate by pulling out the lever that is on the bottom of the oven. See Figure 6.

(B)When lever is out, pull that side of the mounting plate away from the oven. See Figure 5.

(C)Repeat step (A) on other side.

(D)Repeat step (B) on other side.

(A)

(B)

(D)

(C)

Figure 5

	(A)
Use screwdriver to	Mounting
	Plate
assist in releasing
mounting plate.
	Bottom of
	Microwave

Figure 6

E