24 electrolux cleaning and maintenance
After reinserting the inner pane, adjust the retainer “C”, then:
these can damage the surface. Clean the panel with the same care.
C
A
Fig. 5: insert the right end of the perfo- rated aluminium plate ”A” into the recess in the retainer “C”.
DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter.
If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to pre- vent the possibility of the panel shatter- ing. Contact your local Service Centre who will be pleased to advise further.
A
If necessary, it is possible to reverse the oven door. This operation should be carried out by authorized person- nel ONLY.
Customers are recommended not to carry out this operation themselves. This will be a chargeable visit.
Fig. 6: Then insert the left end of the per- forated aluminium plate ”A” into the re- cess in the retainer “B”.
Insert the retainer “B” at this point and check that everything is securely fas- tened and firm.
Appliances in stainless steel or aluminium
We recommend you only clean the oven door with a wet sponge and then dry it afterwards with a soft cloth. Never use scourers, acids or harsh abrasives, as
Replacing The Oven Light
Disconnect the appliance.
If the oven bulb needs replacing, it must comply with the following specifications:
–Electric power: 15 W/25 W,
–Electric rate: 230 V (50 Hz),
–Resistant to temperatures of 300°C,
–Connection type: E14.
These bulbs are available from your local Service Force Centre.
To replace the faulty bulb: