Use and Care
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE HOOD.
For satisfactory use of your hood, become familiar with the various functions of the hood as described below
Suction power 2 LED, this led is ON when suction power 2 is selected.
Motor OFF button
Suction power 3 LED, this led is ON when suction power 3 is selected.
Light OFF button
Light ON button
ON button and motor suction power selection button 1, 2, 3, 1,....
Suction power 1 LED, this led is ON when suction power 1 is selected.
I n t e n s i v e Suction power LED, this led is ON when the i n t e n s i v e suction power is selected.
I n t e n s i v e Suction power button - this suction power willfunctionfor 10 mins. then the hood set
again the
Figure 7
preselected speed
Grease Filter Saturation LED
The Suction power 2 LED is marked with an F. This LED will flash to remind you when the grease filter needs to be cleaned after 40 hours use. Follow the instructions for cleaning filters in this booklet. Once the grease filters have been cleaned, reset the reminder by pressing Motor OFF button for about 3 seconds until you hear the signal (beep).
Should the Suction power 3 LED starts to flash then push ON and power selection button and the Intensive Suction power button simultaneously for more than 3 seconds to stop flashes.
Operating Instructions
The blower should be turned on for about 5 minutes before cooking in order to establish air currents upward through the hood. Use the low speeds for normal use and the higher speeds for strong odors or fumes.
Minimize cross drafts which will reduce the effectiveness of the hood.
8