CHAPTER 2: INSTALLATION
2.2INSTALLING THE BRIM-WT1
Caution: The BRIM-WT1 and the boards associated with the MicroMMAC are sensitive to static discharges. Be sure to use an antistatic wrist strap and observe all static precautions during this procedure. Failure to do so could result in damage to the BRIM-WT1 or the MicroMMAC.
To Install the BRIM-WT1 into the MicroMMAC:
1.Remove the screws from the BRIM slot faceplate at the rear panel of the MicroMMAC as shown in Figure 2-1.
2.Remove the screws from the two standoffs.
Standoff
Faceplate
MicroMMAC
Rear Panel
Figure 2-1. Removing the Faceplate and Standoff Screws
Page 6 | BRIM-WT1 USER’S GUIDE |
