Cabletron Systems BRIM-WT1 manual The Wan Interface Configuration Screen

THE WAN INTERFACE CONFIGURATION SCREEN

3.2THE WAN INTERFACE CONFIGURATION SCREEN

This section describes the features of the WAN Interface Configuration screen. To access the WAN Interface Configuration screen from the Features Selection screen, use the arrow keys to highlight the WAN Int. Config. option, then press the Return key. The WAN Interface Configuration screen shown in Figure 3-4 appears.

MicroMMAC/WT1 LOCAL MANAGEMENT

Cabletron MMW Revision xx.xx.xx

WAN INTERFACE CONFIGURATION

PT# IF# DLCI STATE PT# IF# DLCI STATE

Interface Number:	03
Data Compression: No
Max Xmit Unit:	1518
Line Coding:	Not Used
Active Protocol:	PPP

SAVE	WAN INT CONFIG	RETURN
-F6-

Figure 3-4. WAN Interface Configuration Screen

The following sections describe WAN Interface Configuration screen fields and instructions for setting them.

Interface Number

Displays Interface Numbers 02-26. Use this field to configure the Interface Numbers you assigned to the Timeslots at the WAN Physical Configuration screen. This field only displays the active SYNC and T1 interfaces.

Data Compression

Displays the status of Data Compression. Select Yes to activate Data Compression or No to de-activate. Data Compression is not supported at this time.

BRIM-WT1 USER’S GUIDE Page 15