Instructions
Replacing the light bulbs.
Setting the controls to OFF does not remove power to the light circuit.
Instructions Safety
Refrigerator Compartment—Upper Light
Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool.
To remove the light shield, press on the
Left side of the shield and pull down.
(appearance may vary)
Replace the bulbs with appliance bulbs of the same or lower wattage. Replace the shield by engaging the bottom tab into the slot and applying light forward pressure until the shield snaps in place.
Set the master power switch to the I (on) position and close the grille panel.
Refrigerator Compartment—Lower Light
Instructions Operating
This light is located above the top drawer.
Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool.
Remove items from the shelf above the light shield. Remove the shelf.
Use both hands to grasp each end of the light shield. Press in on the bottom of the shield with your thumbs while rotating the cover up and out.
Replace the bulb with an appliance bulb of the same or lower wattage. Replace the shield by engaging the bottom tab into the slot and applying light forward pressure until the shield snaps in place.
Set the master power switch to the I (on) position and close the grille panel.
Troubleshooting Tips Installation
Freezer Compartment
Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool.
Remove the items from the shelf just below the light shield. Remove the shelf.
To remove the light shield, press down on the top of the shield and pull the tabs out of the slots. Tilt the shield forward and out.
Replace the bulb with an appliance bulb of the same or lower wattage, and reinstall the light shield. Replace the shield by engaging the bottom tab into the slot and applying light forward pressure until the shield snaps in place.
Set the master power switch to the I (on) position and close the grille panel.
Consumer Support
Dispenser
Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool.
The bulb is located in the dispenser under the control panel. Remove the two screws from the light shield. Slide the light shield toward the dispenser to disengage the tabs, then remove the light shield. Remove the light bulb by turning it counterclockwise.
Replace the bulb with a bulb of the same size and wattage. Replace the light shield by sliding the tabs into the slots in the front of the dispenser. Replace the two screws.
Set the master power switch to the I (on) position and close the grille panel.
14