Electrolux 42 Install Door Handles on Stainless Steel Models, Upper End Cap Bottom End Cap

Installation Instructions

11B

INSTALL DOOR HANDLES ON STAINLESS STEEL MODELS

1.Remove handles from cartoning and any other protective packaging.

2.Place handle over pre-installed shoulder bolts (A) that are fastened into door in four locations.

3.While supporting handle and looking at upper end cap, fasten top-most allen set screw (B) with supplied allen wrench, then fasten bottom allen set screw (C). See Figure 1.

4.Repeat Step 3 with bottom end cap using allen set screws (D and E), once upper section of handle is firmly secured to door. See Figure 2.

5.All set screws should be tightened and sub-flush (allen set screw should be buried just below the surface of the end cap) of handle end cap. The end caps should be drawn tight to freezer and refrigerator doors with no gaps.

A	A	B
	C

Figure 1

Upper End Cap

A	A	D
	E

Figure 2

Bottom End Cap

34