Electrolux EI23BC51IW, EI23BC51IS manual Leveling Freezer Drawer if nec- essary

Page 7

Installation 7

Leveling Freezer Drawer (if nec- essary)

1Check gasket seal around top, bottom, and sides of freezer drawer.

2If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate.

3Close drawer and recheck the seal on the gasket

(A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.

Remove Hex	Remove Hex
Head Drawer	Head Drawer
Screw	Screw
Do Not Remove	Do Not Remove
Other Screws	Other Screws
Remove Hex	Remove Hex
Head Drawer	Head Drawer
Screw	Screw

4Tighten four (4) drawer screws.

5Recheck gasket seal.

To level the cabinet using the front rollers:

1Slightly open freezer drawer. Lift the toe grille and gently pull forward (see illustration).

2You can raise or lower each door. Use a ³⁄₈ inch socket wrench to turn the adjustment screws (1 per side).

To raise: turn adjustment screw clockwise.

To lower: turn adjustment screw counterclockwise.

3Ensure both doors are bind-free with their seals touching the cabinet on all four sides and that cabinet is stable.

4After unit is leveled, lower anti-tip leg until it contacts the floor.

Push Against Freezer Drawer

A

B

Grab Drawer

At Center

From Both Sides

Then

Pull Drawer Out

Door

Door

Level Refrigerator & Adjust Doors (if necessary)

Guidelines for final positioning of your refrigerator:

•All four corners of the cabinet must rest firmly on the floor.

•The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly).

•Doors should align with each other and be level.

Most of these conditions can be met by raising or lowering the adjustable front rollers.

Raise

Anti-tip

Leg

Lower

5Install the toe grille by fitting into place.

Image 7

Contents Use & Care Guide Finding Information Definitions SafetyImportant safety instructions Safety PrecautionsElectrical information Understanding features and terms Feature OverviewDoor opening InstallationInstallation LocationGuidelines for final positioning of your refrigerator Level Refrigerator & Adjust Doors if necessaryTo level the cabinet using the front rollers Leveling Freezer Drawer if nec- essaryTo adjust the door stop Retighten screw To adjust the flipper mullion To prepare for removing the doors Drawer is heavy. Use caution when liftingRemoving the Doors Getting through narrow spacesInstalling Freezer Drawer Door Handle Mounting Instructions Installing Door HandlesBefore installing the water supply line, you will need Connecting the Water SupplyIQ-TouchTM Setting cooling temperaturesAlarms ControlsSabbath Mode and the Perfect TempTM Drawer IQ-TouchTMSabbath ModeIce maker operation & care Automatic Ice MakerCrispers Storage FeaturesShelf features DrawersPerfect TempTM Drawer select models To remove the Crisper Drawer for cleaningSpecial items rack select models Cool ZoneTM Drawer select modelsTilt can bins To remove the Perfect TempTM Drawer for cleaningTo change the position of an adjustable door bin DoorsTo Remove Upper Basket Freezer Features varies by modelTilt Wire Shelf Covered Door BinDividers Removal Ideas for storing foods Storing Food and Saving EnergyIdeas for saving energy Understanding the sounds you may hear Normal Operating SoundsReplacing your PureAdvantageTM water filter Changing the Water and Air FiltersWater filter About your advanced water filterAir filter Ordering replacement filtersReplacing your PureAdvantageTM air filter Protecting your investment Care and CleaningOccasion Tips Care and cleaning tipsPart Cleaning Agents Tips and Precautions Vacation and moving tipsTo replace LED Lights Ordering Replacement LED LightsReplacing LED Lights select models Replacing Light Bulbs select modelsConcern Potential Cause Common Solution Common Solutions for ConcernsBefore you call Refrigerator Operations Temperatures Are Too Warm Major Appliance Warranty Information Warranty