Electrolux 86378-KG1 manual Prior to Initial Start-Up

Page 19

Prior to Initial Start-Up

1 Before connecting the appliance to the mains and putting it into ope- ration for the first time, leave the appliance to stand for 30 minutes if was transported upright. After transport on its side, the appliance must be left to stand for 2 hours before putting it into operation. This is necessary to allow the oil to flow back into the compressor. Otherwise the compressor may be damaged.

01. Please clean the appliance interior and all accessories prior to initial start-up (see section: "Maintenance and Cleaning").

2.The appliance must be correctly installed in accordance with the chap- ter "Installation" before it is put into operation for the first time. Care should be especially taken that the mains voltage and frequency avail- able correspond with the appliance’s rating plate.

3.Remove the cold accumulation block from the appliance.

4.Place the cold accumulation block into a drawer only after the optimal storage temperature of -18 °C has been reached, and allow to freeze.

5.After 24 hours place the cold accumulation block at the front of the upper drawer.

6.Re-freeze the thawed cold accumulation block in the same fashion, e.g. after cleaning the appliance.

818 36 55-00/3

19

Image 19

Contents Santo 86378-KG Santo 86378-KG1 Dear customer Contents Contents Refrigerant Important Safety InstructionsPrior to Installation InstallationServicing Child SafetyMaintenance and Cleaning During UseOld Appliances Environmental InformationAppliance Transport PackagingBefore Use Important Ensure door handle is correctly positioned Fitting the Door HandlesRemove the transport fittings from the storage shelves Screw the top door bracket to the door handle 1. MountInstallation Location InstallationAppliance Alignment Refrigerator/freezer needs ventilationElectrical Connection Wire coloured green Yellow must be connected toTerminals in your plug, proceed Carbon filter Reversing The DoorInserting and changing the active carbon filter View of Appliance Appliance DescriptionCold Accumulation Block Freezer tray These buttons are connected to the temperature display Temperature setting buttons Control panel Reset button Temperature DisplaysText display Mode buttonNo words appear in the display Remove the cold accumulation block from the appliance Prior to Initial Start-UpInitial Start-Up Temperature AdjustmentTip Shopping Operating modesFrostmatic and Coolmatic CoolmaticHoliday Switching the Appliance OffSwitching off freezer section when fridge switched off To switch the fridge section on again, press + or buttonSwitching off freezer section when fridge switched on To switch the freezer section on again, press + or buttonControl and Information Systems Power cut warningOpen door warning For the fridge section Temperature warningFor the freezer section Opening the Freezer Compartment Door Function ErrorsLongfresh 0 C cold zone Interior AccessoriesStorage Shelves Variable Inner DoorDismantling of the Bottle- and Can Holder Setting the air moistureQuick Chill Shelf Bottle- and Can HolderChilling of food Quick chillBottle Holder Chilling of cans or bottlesCorrect storage Some foods in the Longfresh 0 C cold zone Dry storage Guidelines for storage timesMoist storage Fruit Storage period TipsFreezing Tips Frozen StoragePreparation of Ice Cubes Storage Goods Symbols/Freezing CalendarDefrosting Freezer Compartment Defrosting Internal Cleaning Maintenance and CleaningAfter everything is dry place appliance back into service External CleaningReplacing the light bulb Food Storage Energy Saving AdviceHints and Tips Normal Operating SoundsWhat to do if Symptom SolutionRefrigerant circuit has been checked for leaks Regulations, Standards, GuidelinesCompressor Technical TerminologyRefrigerant Circuit EvaporatorStandard Guarantee Conditions Guarantee ConditionsCalls may be recorded for training purposes Service & Spare Parts08705 929 Customer CareSubject to change without notice