Electrolux EI30WC40GS, EI36WC40GS, 316488521 manual Step Mark holes, Outside top exhaust

Step 6

For rectangular ducted discharge installations only (otherwise skip to next step)

Attach exhaust adaptor/damper over knockout opening with two exhaust adaptor screws. Make sure

damper pivot is nearest to top/back edge of hood. Remove tape from damper flap.

Step 8

Mark holes

Select the vent option that your installation will require and proceed to that section:

Outside top exhaust

(Vertical duct– 3 1/4”x 10” Rectangular)

Use the diagram or the hood as a template and mark the locations on the cabinet for ductwork, electrical wiring and keyhole screw slots.

Pivot

Top/back edge

Exhaust transition/damper

NOTE: The exhaust adaptor/damper can be installed up to 1 inch on either side of the hood center to accommodate off-center ductwork. In extreme off- center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

Step 7

For round ducted discharge installations only

Re-install the round transition with its screws.

7" Round

Transition

NOTE: The round transition can be installed up to 1 inch on either side of the hood center to accommodate off-center ductwork. In extreme off- center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

Hood mounting screws (4)

Outside top exhaust (Vertical duct–7” Round)

Use the diagram or the hood as a template and mark the locations on the cabinet for ductwork, electrical wiring and keyhole screw slots.

Hood mounting screws (4)