INSTALLATION
Continued
For Built-In Installation
WARNING: A licensed elec- trician must connect the wiring harness to electrical supply following all local codes. Electri- cian must provide a clamp on the box cover to secure the wiring. Wiring should be routed through the bushing in the hole on the outer casing of fireplace.
1.Install snap bushing from blower kit into one hole on rear of remote/blower bracket (see Figure 17). The other hole is for a strain relief clamp (not supplied) to secure incoming electrical supply.
2.Follow steps 2 through 6 in Installing Blower Accessory, page 14.
3.A licensed electrician must follow the wiring diagram to connect incoming electrical supply to fan kit wiring harness (see Figure 18).
4.Plug power cord to outlet receptacle (not provided) as shown in Figure 17. Wind the extra power cord and tie with plastic wire strap (see Figure 17). Set power cord bundle between the remote/blower bracket and outer casing, away from the burner.
5.Test to make sure blower is working properly.
6.Reinstall upper louver beginning with bottom screws (see Figure 11, page 12) and close lower louver.
Extension Cord
Use extension cord if needed. The cord must have a
| Fan Switch |
|
|
|
|
|
|
| |||
| (Auto/Off/On) |
|
|
|
|
|
|
| |||
|
| 1 Auto |
|
|
|
|
|
|
| ||
| Off | 2 |
|
|
|
|
|
|
|
|
|
|
| 3 | Blue |
| Thermostat | ||||||
|
|
| On |
|
|
| Switch | ||||
|
|
|
|
|
| (N.O.) | |||||
110/115 |
|
| Red |
|
|
|
| Blue | |||
V.A.C. |
|
|
|
|
| Blower | |||||
| Black |
|
|
|
|
|
|
|
| Motor | |
|
|
|
|
|
|
| Red |
| |||
|
|
|
|
|
|
|
| ||||
| White |
|
|
|
|
|
| White |
| ||
| Green |
|
|
|
|
|
| Green | |||
Figure 18 - Wiring Diagram For Blower
Accessory Built-In Installation
Blower Bracket | Wire Harness |
| |
Assembly |
|
Screw |
|
Power Cord
Switch
Outlet Receptacle (not included) 
3 2 1
Switch
Plate
Plastic Wire Strap Wire Harness
Lower Louver Door
Clamp Connector (not included)
Remote/ Blower Bracket
Figure 17 - Installing Blower Bracket Assembly
www.desatech.com | 15 |
