INSTALLATION
Continued
OPTIONAL Wireless
Installing Receiver
1. Disconnect wires from the control valve (see Figure 26) .
2. Locate the battery clip mounted on the back of the receiver (see Figure 27).
3. Slide
4. Attach the terminal wires to the battery (see Figure 27).
5. Connect wires from remote receiver to control valve as shown in Figure 28.
6. Install remote receiver unit onto remote/ blower bracket using screws provided (see Figure 28).
Figure 26 - Disconnecting Wires From
Control Valve
Receiver
| Terminal |
Battery | Wires |
| Battery Clip |
Figure 27 - Attaching Battery to Receiver
White Wire to
TH Terminal on
Control Valve
Remote
Receiver
Red Wire to
TPTH Terminal on
Control Valve
Figure 28 - Installing Remote Receiver
Installing 9-Volt Battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery (not in- cluded). Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
Battery | Remote Control Unit |
Cover |
Terminal
Wires
Battery
Housing
Figure 29 - Installing Battery in Hand-
Held Remote Control Unit
optional Wall Mounted Thermostat - GWMT1
WARNING: Read and fol- low installation instructions. Installation should be done by a qualified installer familiar with
WARNING: Do not connect this thermostat to any electrical source! Electrical shock and/or fire hazard will occur.
1.Remove jumper wire from control valve (see Figure 26).
2.Connect one terminal of 25 ft. wire to the “TH” terminal on the control valve. Connect the other terminal to the “THTP” terminal on the control valve. See Figure 30, page 20.
3.Route the 25 ft. wire to a convenient location to mount your thermostat (no outside wall).
IMPORTANT: The wire may be shortened but must not be lengthened.
The thermostat should be mounted 54" above the floor in a location where there is good air circulation. Avoid heat sources such as lamps, direct sunlight, fireplace or heat and air conditioning ducts.
www.desatech.com | 19 |
