Electrolux EFP 60202 user manual Charcoal filter, Replacing the charcoal filter, Fitting

62electrolux maintenance and care

Charcoal filter

•The charcoal filter should only be used if you want to use the hood in recirculation mode.

•To do this you will need an original charcoal filter (available from your local Service Force Centre).

•Replacing the charcoal filter

The charcoal filter cannot be washed nor regenerated.

The charcoal filter should be replaced every 4 months under normal use. Replacement filters are available from your local Service Force Centre.

Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated.

	With normal use the filter should be
	cleaned every second month (when
	using the hood 2,5 hours per day,on
	avarage). The best way to clean the
	filter is in the dishwasher. Use normal
	detergent and choose the highest
	temperature (65º C). Wash the filter
	separately so that no food parts gets
GB	stuck on the filter and later causes bad
	odours. To reactivate the charcoal, the
	filter should be dried in an oven for 10
	minutes with a maximum temperature
	of 100º C.
	After approximately three years of use,
	the charcoal filter should be replaced
	with a new one, as the odour reduction
	capacity will be reduced.

•Fitting

1.Insert the holding frame for the charcoal filter in the shaft of the hood with the 2 lugs facing upwards and then clip into the lower holes.

2.Fix the holding frame on the lower part of the housing of the hood with the 2 screws supplied.

3.Fit the charcoal filter (see paragraph “Charcoal filter”)

4.Refit the grease filters. Push-in the visor.

•To remove proceed in the reverse order.

•Always specify the hood model number, serial number and product number code when ordering replace- ment filters. This information is shown on the rating plate located on the inside of the unit.

•The charcoal filter can be ordered from your local Service Force Centre.