Important! There are some sounds during normal use (compressor, refrigerant circulation).
electrolux 9
Problem
The appliance does not operate. The lamp does not operate.
The lamp does not work.
The compressor oper- ates continually.
Water flows on the rear plate of the refrigerator.
Water flows into the re- frigerator.
Water flows on the ground.
The temperature in the appliance is too low.
The temperature in the appliance is too high.
Possible cause
The appliance is switched off.
The mains plug is not connected to the mains socket correctly.
The appliance has no power. There is no voltage in the mains socket.
The lamp is in
The lamp is defective.
The temperature is not set cor- rectly.
The door is not closed correctly.
The door has been opened too frequently.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting process, frost defrosts on the rear plate.
The water outlet is clogged.
Products prevent that water flows into the water collector.
The melting water outlet does not flow in the evaporative tray above the compressor.
The temperature regulator is not set correctly.
The temperature regulator is not set correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same time.
There is no cold air circulation in the appliance.
Solution
Switch on the appliance.
Connect the mains plug to the mains socket correctly.
Connect a different electrical appli- ance to the mains socket. Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than necessary.
Let the product temperature de- crease to room temperature be- fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de- crease to room temperature be- fore storage.
Store less products at the same time.
Make sure that there is cold air cir- culation in the appliance.
Replacing the lamp | 1. Disconnect the mains plug from the |
| mains socket. |