Electrolux JRG 90106 Daily Use, Do not put hot pot on the plastic parts in the appliance

Page 3

damage to the cord may cause a short- circuit, fire and/or electric shock.

Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel.

1.Power cord must not be lengthened.

2.Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or dam- aged power plug may overheat and cause a fire.

3.Make sure that you can come to the mains plug of the appliance.

4.Do not pull the mains cable.

5.If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire.

6.You must not operate the appliance without the lamp cover1) of interior lighting.

This appliance is heavy. Care should be taken when moving it.

Do not remove nor touch items from the freezer compartment if your hands are damp/wet, as this could cause skin abra- sions or frost/freezer burns.

Avoid prolonged exposure of the appli- ance to direct sunlight.

Bulb lamps2) used in this appliance are special purpose lamps selected for house- hold appliances use only. They are not suitable for household room illumination.

Daily Use

Do not put hot pot on the plastic parts in the appliance.

Do not store flammable gas and liquid in the appliance, because they may explode.

Do not place food products directly against the air outlet on the rear wall.3)

Frozen food must not be re-frozen once it has been thawed out.

Store pre-packed frozen food in accord- ance with the frozen food manufacturer's instructions.

Appliance's manufacturers storage rec- ommendations should be strictly adhered to. Refer to relevant instructions.

electrolux 3

Do not place carbonated or fizzy drinks in the freezer compartment as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance.

Ice lollies can cause frost burns if con- sumed straight from the appliance.

Care and cleaning

Before maintenance, switch off the appli- ance and disconnect the mains plug from the mains socket.

Do not clean the appliance with metal ob- jects.

Do not use sharp objects to remove frost from the appliance. Use a plastic scraper.

Regularly examine the drain in the refriger- ator for defrosted water. If necessary, clean the drain. If the drain is blocked, wa- ter will collect in the bottom of the appli- ance.

Installation

Important! For electrical connection carefully follow the instructions given in specific paragraphs.

Unpack the appliance and check if there are damages on it. Do not connect the ap- pliance if it is damaged. Report possible damages immediately to the place you bought it. In that case retain packing.

It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor.

Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve sufficient ven- tilation follow the instructions relevant to installation.

Wherever possible the back of the prod- uct should be against a wall to avoid touching or catching warm parts (com- pressor, condenser) to prevent possible burn.

The appliance must not be located close to radiators or cookers.

Make sure that the mains plug is accessi- ble after the installation of the appliance.

Connect to potable water supply only.4)

1)If the lamp cover is foreseen

2)If the lamp is foreseen

3)If the appliance is Frost Free

Image 3
Contents Refrigerator Safety Information ContentsDo not put hot pot on the plastic parts in the appliance Care and cleaningInstallation Daily UseControl Panel Daily USE First USEHumidity control Movable shelvesPositioning the door shelves Bottle holderHelpful Hints and Tips What to do IF… Care and CleaningMains socket Replacing the lampPositioning Technical DataInstallation Closing the doorVentilation requirements Environmental ConcernsRemoving the shelf holders Electrical connection212710061-00-17062010