Installing a firmware card
4 Align the notches on the bottom of the card with the notches on the connector.
5 Push the memory card firmly into the connector until the latches on either end of the connector snap into place.
It may require some force to fully seat the card.
6 Make sure each latch fits over the notch on the end of the card.
Follow the instructions in this section to install a firmware card.
If you have a network internet model, an ImageQuick™ firmware card is already installed.
Note: Firmware cards designed for other printers may not work with your new printer.
If an option card has been installed, you need to remove the option card before installing the firmware card.
1 Remove the system board access cover (see page 24).
