40 electrolux installation
(Attention! NOT all models of dishwashers have fill and drain hoses provided with locknut. In this case, this kind of facility is not possible).
If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose.
DO NOT use connection hoses which have previously been used for an old appliance.
This appliance has been fitted with safety features which will prevent the water used in the appliance from returning back into the drinking water system. This appliance complies with the applicable plumbing regulations.
Water inlet hose with safety valve
After connecting the
Please take care when installing the water inlet hose:
●The electrical cable for the safety valve is in the
●If water inlet hose or the safety valve is damaged, remove the mains plug immediately.
●A water inlet hose with safety valve must only be replaced by a specialist or by the Service Force Centre.
●Place the water inlet hose in such a way that it is never higher than the bottom edge of the safety valve.
Warning! Dangerous voltage