![](/images/new-backgrounds/1041139/4113953x1.webp)
The furniture door
The door on this appliance is designed for the overlay or a panel having the following dimensions:
Width: | 596 mm |
Height: | 604 mm max |
Thickness: | 20 mm max |
Weight: | 2 - 7.5 kg max |
The panel height should be no more than indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth.
Furthermore, it is possible to line up the control panel to correspond with the height of the drawers of the adjacent pieces of furniture, thus perfectly
Add one or more of the fillets provided until you reach the desired height.
Secure the fillets as shown in the picture, by means of two screws 4 x 40 provided therewith.
A |
A |
II04 |
Prepare the panel as follows:
Measure the distance (B) between the part below the control panel (or fillets) and the reference notch (X) on the door.
Measure the same distance (B) on the wooden panel starting from the upper edge.
At this distance position the supporting
Keep the same distance between the centre of the support’s fastening holes and the lateral edges of the wooden panel.
On the panel sign the seats for the four fastening screws. Drill the panel with a Ø 2 x 12 bit and fix the supporting
Mount the decor panel by inserting the two pivots of the
Lift the decor panel until the perfect alignment with the facia panel is obtained.
Once the correct position has been found, open the door and fasten the decor panel on the lower section by means of the two 4 x 40 screws provided, using the holes through the inner door.
|
| X |
| 1 | B |
| Z | |
|
| |
= |
| B |
550 |
| |
| = | |
|
| |
| II22 | 2 |
|
|
II10 |
27 | PFI05UK |