Electrolux ESI 600 Before use, Setting the water softener, To adjust the water softener Level

Before use

Before using your dishwasher for the first time:

☞ensure that the electrical and water connections comply with the installation instructions

☞remove all packaging from inside the appliance

☞set the water softener

☞fill the salt container

☞fill the rinse aid dispenser.

Setting the water softener

The dishwasher is equipped with a water softener designed to remove minerals and salts from the water supply, which would have a detrimental or adverse effect on the operation of the appliance.

The higher the content of these salts, the harder your water is.

Water hardness is measured in equivalent scales, Clarke degrees and French degrees.

The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area.

The dishwasher is factory set at level 2.

If this level is not suitable for your area the softener should be adjusted.

☞To adjust the water softener:

Level 1

If your water is "level 1" it is already soft and therefore there is no need to use salt.

Levels 3 and 5

(water softener adjustment)

If your water is level 3 or 5, proceed as follows:

-slide out the lower basket and unscrew the cap of the salt container;

-turn the two-position selector anticlockwise from position - to position + with the aid of a knife or screwdriver.

Levels 4 and 5

(adjustment on the machine)

If your water is level 4 or 5, open the door and drill membrane (A) on the upper left-hand corner of the machine.

With a water hardness of level 5 both adjustments must be made.

	Water
	hardness			Water	Adjustment
			Level	softener	on the
	Clarke	French
	degrees	degrees		adjustment	machine
0 - 10		0 - 14	1	NO	NO
11 - 27		15 - 39	*2	NO	NO
28 - 35		40 - 50	3	YES	NO
36 - 49		51 - 70	4	NO	YES
50 - 63		71 - 90	5	YES	YES

* factory setting

AA02

A

AA04

6 PBU02UK