![](/images/new-backgrounds/1042613/4261339x1.webp)
20electrolux
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots or a blu- ish coating on glasses and dishes
Water drops have dried onto glasses and dishes
The wash results are not satisfactory
•The wrong programme has been selected.
•The dishes are arranged in such a way as to stop water reaching all parts of a surface. The baskets must not be overloaded.
•The spray arms do not rotate freely due to incorrect arrangement of the load.
•The filters in the base of the washing compartment are dirty or incorrectly positioned.
•Too little or no detergent has been used.
•Where there are limescales deposits on the dishes; the salt container is empty or incorrect level of the water softener has been set.
•The drain hose connection is not correct.
•The salt container cap is not properly closed.
•Rinse aid was not used.
•The rinse aid dispenser is empty.
•Decrease rinse aid dosage.
•Increase rinse aid dosage.
•The detergent may be the cause. Contact the detergent manufacturer con- sumer care line.
If after all these checks, the problem persists, contact your local Service Force Centre.
Technical data
Dimensions
Electrical connection - Voltage - Overall power - Fuse
Water supply pressure
Capacity
Width | 45 cm |
Height | 85 cm |
Depth | 63 cm |
Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door.
Minimum | 0,05 MPa (0,5 bar) |
Maximum | 0,8 MPa (8 bar) |
| 9 place settings |
|
|
Hints for test institutes
Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (refer to 'Washing programmes').
Test in accordance with EN 50242 must be carried out when the salt container and rinse
aid dispenser have been filled with salt and rinse aid respectively and using the test pro- gramme (refer to 'Washing programmes').
Full load: 9 standard place settings
Amount of detergent required:
Rinse aid setting
5 g + 20 g (Type B)
position 4 (Type III)
Testing MUST be carried out with:
•NO soft spikes
•NO mini cutlery basket.
REMOVE these items from the upper basket.