Electrolux ESF 46710 user manual First use, Set the water softener, Function buttons, Setting mode

•the approximate remaining time of the run- ning programme,

•activation/deactivation of the rinse aid dis- penser ( ONLY with 'Multitab function' ac- tive),

•the end of a washing programme (a zero will appear in the digital display),

•the countdown for the delay start,

•fault codes concerning malfunction of the dishwasher.

Function buttons

The following functions can be set using these buttons:

•the adjustment of the water softener level,

•cancel a washing programme or a delay start in progress,

•activate/deactivate the Multitab function,

•activate/deactivate the rinse aid dispenser when the Multitab function is active.

Setting mode

Press the On/Off button; if ALL programme button lights come on, the appliance is in setting mode.

Always remember that when performing the following operations:

–selecting a washing programme,

–setting the water softener level,

–activating/deactivating the rinse aid, the appliance MUST be in setting mode.

Press the On/Off button; if a programme but- ton light comes on, the last performed or se- lected programme is still set. In this case, to return to setting mode, the programme has to be cancelled.

To cancel a set programme or a programme in progress

Simultaneously press and hold the two func- tion buttons B and C until all the programme button lights come on. The programme has been cancelled and the machine is now in setting mode.

Before using your dishwasher for the first time:

•Ensure that the electrical and water con- nections comply with the installation in- structions

•Remove all packaging from inside the ap- pliance

•Set the water softener level

•Pour 1 litre of water into the salt container and then fill with dishwasher salt

•Fill the rinse aid dispenser

If you want to use combi detergent tablets such as: ''3 in 1'', ''4 in 1'', ''5 in 1'' etc... set the Multitab function. (See ''Multitab function'').

The dishwasher is equipped with a water softener designed to remove minerals and salts from the water supply, which would have a detrimental or adverse effect on the operation of the appliance.

The higher the content of these minerals and salts, the harder your water is. Water hard- ness is measured in equivalent scales, Ger- man degrees (dH°), French degrees (°TH) and mmol/l (millimol per litre - international unit for the hardness of water).

The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area.

The water softener must be set in two ways: manually, using the water hard- ness dial and electronically.