Electrolux 583398 manual Switching on, Programming the cooking time and the starting time or, Soft

OPERATING INSTRUCTIONS

4.3Automatic cooking

TT Button, activation of settings

LT	Lamp, cooking temperature
DT	Button, cooking time
LD	Lamp, cooking time expires
ZT	Button, starting time
LZ	Lamp, starting time
LR	Lamp, soft settings

QButton, acoustic signal

RButton, soft

LS Lamp, temperature pre-setting

AT Display, cooking tempera- ture

TTemperature selection knob AD Display, remaining cooking

time

D Cooking time knob AZ Display, time

Z Starting time knob

LU LC C U

S Control switch

Fig. 3 Right console

Switching on

Switch on the control switch (S) turn from position 0 to I. This switches on the temperature pre-setting function. The lamp (LS) lights up.

0 = Off

I = On

Set the desired cooking temperature (flashing nominal value) with the temperature selection knob (T) on the display (AT).

Turn right = increase Turn left = reduction Smallest change = 1°F

Programming the cooking time and the starting time (or

only one function).

Pressing the button (DT) switches on the programme for the cooking time (flashing nominal value). The desired cooking time is set with the cooking time knob (D) on the display (AD).

Turn right = increase Turn left = reduction Smallest change = 1 minute

The lamp (LD) only lights up when the desired temperature has been reached and the cooking time expires.

The following pre-programmed nominal functions Cooking temperature

Cooking time

are all activated by pressing the button (TT). The following displays

Cooking temperature (AT) Remaining cooking time (AD) indicate the current value.

The lamp (LT) will continue to flash until the nominal cooking temperature is reached. It then stays on permanently.

Observing the flames

The window in the front cladding wall of the pan can be used to determine whether the burner has ignited and the flames are evenly distributed.

4.4Shutting down

An acoustic signal sounds when cooking is over. This is acknowledged by pressing the button (Q).

The power supply is then switched off.

All activated functions are subsequently switched off:

•Press the pre-set temperature button (TT) for some sec- onds.

Lamp (LT) goes out.

•Press the cooking time button (DT). Lamp (LD) goes out.

•Switch off the control switch (S). Turn from position I to 0.

Lamp (LS) goes out.

•Switch off the power isolator (H) (only available as an option).

•Turn from position I to 0.

0 = Off

After cooking has been completed, the control switch (S) is switched off.

•Turn from position I to 0. 0 = Off

•The lamp (LS) goes out.

•Switch off the power isolator (H) (only available as an option).

Turn from position I to 0.

0 = Off

The appliance can be switched off before cooking has been completed.

If the function buttons (TT), (DT) and (ZT) are switched on and switching off is only done by means of the control switch (S), all the functions and previously set data for temperature, cook- ing time and starting time remain saved and active when the switch (S) is turned on again.

IIf the appliance develops a fault, the electrical switch in the building must also be switched off and the gas valve must be closed.

4.5Additional functions

SOFT

Pressing the Soft button (R) adapts the power supply to the food, i.e. reduces it.

The lamp (LR) on the button (R) lights up if the soft setting has been switched on.

The following functions are activated by pressing button (Q):

1. All displays

Food temperature (AT)

Cooking time (AD) Starting time (AZ)

flash indicating the nominal value that has been pro- grammed in.

2.Acknowledgement of the acoustic signal when cooking has been completed.

3.Acknowledgement of error messages (see section 12, Troubleshooting).

Page 6 62.9695.01