8Operating Instructions
Wash Pressure
The WASH PRESSURE option allows you to select the desired wash pressure depending on your dishload. When HIGH WASH PRESSURE is selected, the system automatically adjusts the pressure up to provide faster and more effective cleaning. When LOW WASH PRESSURE is selected, the wash pressure is decreased to clean delicate dishes without damage. When AIR DRY is selected, heat dry will not be activated this will conserve energy and time.
Start/Cancel
To start a cycle, press the START touchpad once and close the door. To cancel when a cycle is running, open the door and press the CANCEL touchpad once. Close the door again and the dishwasher will drain and shut off.
NOTE
Opening the door during normal operation will only pause the selected cycle.
Error Indications
In certain situations which are critical to the ma- chine function and safe operation, the control shall shut down and indicate an error code ‘Er’ (See Error Codes on page 21). On units without a display, all indicator lights will flash.
If one of these codes are displayed contact the Electrolux Customer Care Center at
BLUE LIGHT
When BLUE LIGHT luminates on the floor this indicates that the wash cycle is complete.
CHIME
These models are equipped with a chime to audibly indicate when you have pressed a cycle or selected an option. The chime also signals the completion of the selected cycle.
To adjust the volume press the “SELECT OPTION” touchpad. Then toggle using the > touchpad until VOLUME SETTING is displayed. Press the “SET” touchpad and then toggle using the < or > touchpads until the desired volume is reached. Press the “SET” touchpad to save your selection.
DISABLE THE DISPLAY
The disable the display feature may be used when observing the Jewish Sabbath/Holidays and the dishwasher may be used for storage during this time.
When the display is properly disabled, the dishwasher will not provide any audibles or text messages.
You can set your wash cycle to run. To do this, press Start, then disable the display and close the dishwasher door. After the completed wash cycle the clean light will remain ON even when you open or close the door during this time. The clean light will shut OFF automatically 2 hours after the completed wash cycle.
You can also disable the display without setting a wash cycle.
To disable the display press and hold the left arrow key for 10 seconds. To reactivate the display, press and hold the left arrow key for 10 seconds.
STATUS WINDOW
The STATUS window displays codes typically seen during programming of the dishwasher. The window will not display anything when the door is closed.
The STATUS window indicates the following activity:
CLOSE DOOR Displayed once the program has been entered and the START/ CANCEL touchpad is pressed. It also flashes if the door is opened during a wash cycle. Close the dishwasher door to begin or continue a wash cycle.
WELCOME Appears in window 3 seconds when dishwasher is first installed, or when power has been interrupted.