Electrolux RM 850CN, RM 850GRN manual Oven Bulb Replacement, Burners, To replace the faulty bulb

Page 14

DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter.

If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering.

Contact your local Service Centre who will be pleased to advise further.

IMPORTANT: The inner door glass must be in place when using the oven.

Hob

After every use wipe with a soft cloth well wrung out in warm water to which a little washing up liquid has been added, avoiding any leakage through the holes of the hob. Rinse and dry with a soft cloth.

To remove more stubborn stains, wet and leave to dissolve, do not scratch and avoid the use of abrasive or caustic products that could damage the enamel.

Burners

The burner caps and crowns can be removed for cleaning.

Wash the burners caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well-moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove.

After cleaning, be sure to wipe dry with a soft

fig. 18

cloth.

 

OVEN BULB REPLACEMENT

Ensure that the appliance is switched off and disconnected from the electricity supply before replacing the bulb to avoid possibility of an electric shock.

If the oven bulb needs replacing, it must comply with the following specifications:

Electric Power:

15W

 

Electric Rate:

230/240V (50Hz)

 

Resistant to temperatures of:

300ºC

 

Connection Type:

E14

 

 

To replace the faulty bulb.

 

1.

Turn the glass cover anti clockwise and

 

 

remove.

 

 

2.

Remove the faulty bulb and replace with a

 

 

new one.

 

 

3.

Refit the glass cover.

 

 

4.

Reconnect the appliance

to the electricity

fig. 31

 

supply.

 

 

Burner cap

Burner

ring

Ignition

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents RM 850GRN Page Contents Service Important Safety InformationChild Safety During UseModels RM850CN and RM850GRN Description of the ApplianceHob Control panelControl knob Explanations of symbolsUSE of Appliance Bottom heating element It is necessary to pre-heat the oven How to proceed ?It is not necessary to preheat the oven How to proceed ? Top heating elementOven Thermostat pilot light GrillingBrowning Condensation and steam How to use the rotisserieMaximum weight permitted on the rotisserie is 4·5 kg CookwareOven thermostat pilot light Timer Minute MinderOven Cooking Ignition of the burners Burner Power Diameter mmSelecting the Correct burner Mains FailureImportant Never use for Storing Inflammable materials Accessories delivered with the applianceStorage Compartment Oven Cavity Cleaning materialsExternal cleaning Oven Door GlassBurners Oven Bulb ReplacementTo replace the faulty bulb Symptoms Solutions Something not WorkingService and Spare Parts Customer CareEuropean Guarantee Guarantee ConditionsStandard Guarantee Conditions ExclusionsInstructions for the Installer Connection to gas supplyTechnical Features Location VentilationAssembling of back panel Electrical Connection This Cooker Must be EarthedLeft Hand Connection from front GAS ConnectionRight Hand Connection from front Rigid Connection Position of the cylinder propane bottleGas Type Pressure Conversion of GASTable no.1 Cat II 2H3+ Burner ConsAdjustment of minimum level for the hob burners
Top Page Image Contents