Electrolux EKD60760 Switching on the clock display, Oven safety switch-off, Using the Meat probe

20electrolux

As soon as the oven is switched on again, the display comes on automati- cally. When the appliance is switched off again, the cock display goes out again. To have the clock display on permanent- ly again, you must set the clock again.

Switching on the clock display

1.If required, switch off the appliance using the On/Off button.

2.Press the Selection button and button at the same time until the display is visible again.

Oven safety switch-off

If the oven not switched off after a certain time, or if the temperature is not modi- fied, it switches off automatically. The last temperature set appears in the tem- perature display.

The oven switches itself off when the oven temperature is:

•30 - 120oC after 12.5 hours

•120 - 200oC after 8.5 hours

•200 - 250oC after 5.5 hours

•250 - maxoC after 3.0 hours

Using the appliance after a safety cut- out:

Switch the oven off completely. It can then be switched on again.

The safety cut-out is cancelled, if the

clock function Cooking time / Stop time or the oven function Low tem- perature cooking is set.

Using the Meat probe

Warning! Be careful not to burn yourself on the heating coils in the top of the oven, or on the oven step units when you connect or disconnect the contact to the meat probe. Use oven gloves.

The meat probe tolerates temperatures of between 30 and 99°C. Use only the original

thermometer and make sure that no part of the thermometer comes into contact with the top heating element.

For the best result, the tip of the thermometer must be in the centre of the meat which heat reaches last. Oven heat influences the ther- mometer, therefore the whole tube must be inside the meat. Remember that the ther- mometer can show the wrong temperature if it comes into contact with fat or bone.

Put in the food from a cold oven.

Setting:

1.Stick the meat probe into the meat.

2.Connect the meat probe into the outlet in the oven (right-hand side).

3.Start the oven .

4.You can now set the desired temperature

by pressing or . 60ºC is the pre-set temperature.

The display changes to the current core temperature.

If the current core temperature has al- ready been displayed, before the desired

core temperature is set, then press the Selection button repeatedly, until the function Meat Probe flashes and then carry out the setting.

30ºC is the lowest temperature that are shown in the display.

5.Choose oven function and temperature. When the desired temperature in the meat is reached, a signal sounds and the oven switches off.