Malfunction |
| Possible Cause |
| Remedy |
|
|
|
|
|
The freezer temperature is not sufficient, red light lights up, temperature signal sounds
Temperature is not properly adjusted.
Door was open for an exten- ded period.
A large quantity of warm food was placed in the appliance within the last 24 hours.
Please look in the "Initial Start Up" section.
Open the door only as long as necessary.. Press the fast free- ze switch
Press the fast freeze switch
Heavy build up of frost, possi- bly also on the door seal.
Unusual noises.
The appliance is near a heat source.
Problems on the appliance
Door seal is not air tight (pos- sibly after changing over the hinges).
Appliance is not level.
The appliance is touching the wall or other objects.
A component, e.g. a pipe, on the rear of the appliance is touching another part of the appliance or the wall.
Please look in the "Installation location" section.
Switch on the fast freeze switch, keep the freezer clo- sed, inform your customer service
Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component out of the way.
The compressor does not start immediately after changing the temperature setting.
If the door remains open for more than 7 min., the light will be switched off by the electronics.
This is normal, no error has occurred.
This is normal, no error has occurred.
The compressor starts after a period of time.
Close the door and
20