Installation
Electrical Connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety measures not be observed.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left.
The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
Important!
The wires in the mains lead are coloured in accordance with the fol- lowing code:
Green and Yellow Earth
BlueNeutral
BrownLive
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured mark- ings identifying the terminals in your plug, proceed as follows:
GREEN & YELLOW | 13 AMP. FUSE |
|
13 AMP |
| BROWN |
| BLUE |
D207 | CORD CLAMP |
|
1.The wire coloured green and yellow must be connected to the terminal marked with the letter “E” or by the earth symbol or coloured green and yel- low.
2.The wire coloured blue must be connected to the terminal marked “N” or coloured black.
3.The wire coloured brown must be connected to the terminal marked “L” or coloured red.
4.Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
Warning! A
Attention! it must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installa-
24
tion.