Remove transport packaging
The appliance and the interior fittings are protected for transport. ☞1. Pull off the adhesive tape on the left and right side of the door.
2.Remove all adhesive tape and packing pieces from the interior of the appliance.
Installation
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use and efficient performance of the appliance is affected by the ambient temperature.
The appliance should therefore
–not be exposed to direct sunlight;
–not be installed next to radiators, cookers or other sources of heat;
–only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.
The climate classification can be found on the serial plate, which is located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each climate classification:
Climate classification |
| for an ambient temperature of |
|
|
|
|
|
|
SN |
| +10 to +32 °C |
|
|
|
|
|
|
N |
| +16 to +32 °C |
|
|
|
|
|
|
ST |
| +18 to +38 °C |
|
|
|
|
|
|
T |
| +18 to +43 °C |
|
|
|
Installation directly under a hob is not allowed. The temperatures of the hob, which in part are quite high, may damage the appliance.
If a hob is installed near the appliance, the corresponding installation and safety instructions must be adhered to. Considering the numerous installation conditions which are possible, there is no way of providing detailed information here.
It is necessary to avoid overheating of the refrigerator by maintaining
7