Installation
The mains cable may only be changed by a qualified electrician or competent person. If your appliance needs repairing, please contact your local AEG Service Force Centre.
Electrical Connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety mea- sures not be observed.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the right.
The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
Important
The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow Earth
BlueNeutral
BrownLive
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the termi- nals in your plug, proceed as follows:
GREEN & YELLOW | 13 AMP. FUSE |
|
13 AMP |
| BROWN |
| BLUE |
D207 | CORD CLAMP |
|
1.The wire coloured green and yellow must be connected to the termi-
nal marked with the letter “E” or by the earth symbol 
or coloured green and yellow.
2.The wire coloured blue must be connected to the terminal marked “N” or coloured black.
3.The wire coloured brown must be connected to the terminal marked “L” or coloured red.
4.Upon completion there must be no cut, or stray strands of wire pre- sent and the cord clamp must be secure over the outer sheath.
Warning! A
17