Symptom |
| Possible Cause |
| Remedy |
|
|
|
|
|
|
|
|
|
|
The compressor does not |
|
|
|
|
start immediately after |
| This is normal, no error has |
| The compressor starts after |
changing the temperature |
| occurred. |
| a period of time. |
setting. |
|
|
|
|
|
|
|
|
|
Water in the bottom of |
| Water drain hole is |
| See the “Cleaning and |
the cabinet. |
| blocked. |
| Care” section. |
|
|
|
|
|
Changing the Light Bulb
Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or disconnect from the
power supply. | Light bulb data: |
☞1. To switch off the appliance, turn the thermostat knob to position "0".
2.Unplug the mains plug.
3.To change the light bulb, undo the screw.
4. Press the light bulb cover as shown and slide it backwards.
5.Change the defective light bulb.
6.Refit the light bulb cover and the
screw.AEG65
7.Put the refrigerator back into operation.
Regulations, Standards, Guidelines
This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), acci- dent prevention regulations for refrigeration appliances (VBG 20) and the regulations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.
This appliance is in accordance with the following EU guidelines:
–73/23/EWG dated 19 February 1973 - low voltage guidelines.
–89/336/EWG dated 3 May 1989
(including guideline change notice 92/31/EWG) - EMV guideline
28