CLEANING INSIDE THE OVENS
The vitreous enamel coating in the ovens can be cleaned using normal oven cleaners or aerosol oven cleaners with care. Ensure that the manufacturers instructions are followed and that all parts are well rinsed afterwards.
Aerosol cleaners must not come into contact with elements or the door seal as this may cause damage.
CLEANING THE DOOR GLASS
To prevent damaging or weakening the door glass panels avoid the use of the following:
Household detergents and bleaches Impregnated pads unsuitable for
Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers
Bath/Sink stain removers
Under no circumstances should the door assembly be detached from the product for cleaning. Please refer to the cleaning instructions.
TO REMOVE THE INNER GLASS
1.Fully open the oven door.
2.Firmly grasp the rear edge of the inner glass panel with both hands.
3.Push the glass panel towards you until it clears the hinge location points at the rear.
4.With one hand, carefully lift the glass panel to disengage it from the location points under the handle. (With your other hand, hold the outer door to ensure it does not spring shut on removing the inner panel).
5.Close the oven door.
If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Centre who will be pleased to advise further.
Hinge location point
Hinge location point
32