Electrolux TRIMKITSS1, TRIMKITEZ1 Leveling System Install Single and Dual Installations

INSTRUCTION SHEET

Setting Up The Trim And Grill Assembly (Single and Dual Installations)

1.Lay the parts out on a cleared area face down. Be sure to place a drop cloth over the floor to prevent scratching trim kit and/or floor. (See Figure 1).

Figure 1

2.Cut 4” (101.6 mm) off the left and right Side Trim using the slot as a guide to make the proper size for a 75”

(1905 mm) cut-out. (See Figure 2).

NOTE: DO NOT cut the side trim if installing in a 79” (2006 mm) opening.

Side Trim

Left and Right

Sides

Leveling System Install

(Single and Dual Installations)

3.a. Lie unit on its back on packaging material or a drop cloth to prevent damage.

b.Remove (3) screws from each side and discard. (See Figure 3)

c.Remove and save both plastic leg levelers to use in the next step.

Remove Leg Levelers

Remove And Discard

Screws

Remove Leg Levelers

Figure 3

4.a. Attach the current leg leveler to leveling system. The leg leveler is a common part that will work on both bottom sides of the unit. (See Figure 4).

b.Attach leg leveler with three (3) screws per side using a 3/8 socket.

c.Re-install the leg levelers.

d.In order to provide clearance to access the rear screw hole, adjust the rear roller up out of he way. When finished, lower the rear roller back to its initial position.

Figure 2

Install Leg Levelers

Install Screws

(3 per side)

Figure 4

©2013 Electrolux Home Products, Inc. Instruction Sheet A00343901 11.04.13