Installation and Connection
Installation
1.Remove any promotion label from the door.
2.Install the oven on a flat, level surface. The surface must be strong enough to safely bear the weight (22 kg) of the oven, and the contents. To avoid the possibility of causing vibration or noise the oven must be in a stable position.
3.Keep the oven away from heat and water. Exposure to heat and water can lower oven efficiency and lead to malfunctioning, so be sure to install the oven away from heat and water sources.
4.Do not block air vents on the top and the sides of the cabinet and also do not place any articles on the top of the oven. If air vents are blocked during operation, the oven may overheat, and this may lead to malfunctioning. Hot air escapes from the vents, so be sure not to obstruct it or let curtains come between the oven and the rear wall.
5.Place the oven as far away from radios and TV’s as possible. This oven does conform to EEC requirements* of radio interference suppression, but some interference may occur if it is placed too close to a radio or TV, so keep them as far apart as possible.
•This appliance conforms to the requirements of EEC Radio Interference Directive 87/308/EEC.
Connecting to the mains
•The oven is delivered with the power cord and a plug for 230
•Earth protection minimizes the risks should a short circuit occur. Check to ensure the voltage of the oven matches the supply.
N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.
1WARNING! This appliance must not be used on a nonearth protected power supply.
•Contact an electrician if you are uncertain regarding electrical connection of the oven or provision of earth protection of the supply.
•This appliance must be earthed. If this appliance is fitted with a non- rewirable plug for which your socket is unsuitable, the plug should be cut off and the appropriate plug fitted. If it is necessary to change the fuse in a nonrewirable plug, the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement is obtained.
12
