Viking M0905VR manual Griddle/Simmer Plate Operation, Grill Operation

Page 7

Griddle/Simmer Plate, Bake Burner, Infrared Burner

Turning the thermostat counter clockwise to any “on” position activates a glo-bar igniter and opens an electromechanical valve in the system to start the gas valve. The griddle has a power “ON” light which glows when the griddle thermostat is turned on. the light cycles on and off with the burner. It is not possible to use both the infrared burner and the bake burners at the same time. The design of the system will not permit this, both for control of bake/broiler and for safety of use.

Griddle/Simmer Plate Operation

•Turn the griddle control knob to desired temperature setting. •Always turn off when not in use, or lower the heat between cooking loads.

Cooking Tips

•Preheat griddle to the desired temperature. Wait until light cycles off for indication that the desired temperature has been reached and the griddle is preheated.

•Use liquid cooking oil, cooking sprays, or butter for eggs, pancakes, French toast, fish and sandwiches. This will help to reduce sticking. Meats usually have enough natural oils.

•Remove food particles with a metal spatula during cooking to make the cleanup easier and to avoid including those particles in the food. •Do not overheat the griddle. Turn off when not in use, or lower heat between cooking loads.

•After using and cleaning the griddle, the surface should be wiped with a light film of cooking oil to protect the finish from rust and corrosion.

Griddle Cooking Chart

 

Food

oF

oC

 

 

Eggs

250-300

121-149

 

 

Bacon

325-300

163-177

 

 

Pancakes

375-400

191-177

 

 

French Toast

400

205

 

 

Fish Fillets

300

149

 

 

Hamburger

350

177

 

 

Steaks

350

177

 

 

 

 

 

 

Grill Operation

•Turn on ventilator (separate product). •Turn control knob to HI.

•Preheat on HI for 5 to 10 minutes. •Place food on grill, cook as desired.

Grill Cooking Tips

•When grilling chicken, roasts, well done steaks or chops and thick pieces of meat, sear on HI. Then, reduce the heat setting to prevent excessive flare-up. This will allow the food to cook through without burning the outside.

•After steaks, chops, or hamburgers have been allowed to sear for approximately 1 minute, you may slide a spatula under the meat and turn it approximately 90o so that a waffle pattern will be seared onto the food.

•Use a metal spatula instead of tongs or a fork to turn the meat. A spatula will not puncture the meat allowing juices to escape.

•Turn the meat over only once. Juices are lost when steaks, chops or hamburgers are turned several times. The best time to turn the meat is after the juices have begun to bubble to the surface.

•To test for doneness, make a small slash in the center of the meat, not the edge. This will prevent loss of juices.

•Occasionally there may be flare-ups or flames above the grill due to drops of fat falling onto the flame spreader. It is normal to have some flare-up during grilling. Use a long handled spatula to move food to another area until the flames subside.

12

13

Image 7
Contents Viking Freestanding Gas Self-clean RangesCongratulations Table of ContentsImportant Safety Instructions Before You Use Your New Range Cooking UtensilsBasic Functions of Your Oven Infrared Broil Temperature Setting Guidelines Heat Setting USE Using Your Range Lighting the BurnersGrill Operation Griddle/Simmer Plate OperationGrill Cooking Chart Oven Operation Natural Airflow Baking/ Convection Baking Page Conventional Baking Chart Solving Baking ProblemsPork Conventional/Convection Roasting TipsInfrared Convection Broiling Infrared Conventional BroilingConvection Dehydration Conventional/Convection Broiling ChartConvection Defrosting Cleaning and Maintenance Page Burn or Electrical Shock Hazard Self-Clean CycleReplacing Interior Oven Lights Power FailureViking Range Corporation Preferred Service Service Information