Viking F20497 manual Setting the Controls, Solid Door Models, Glass Door Models

when TruProtect™ is enabled.

SETTING THE CONTROLS

The temperature of the refrigerated beverage center ranges from 40ºF to 65°F (4ºC to 18ºC).

TruProtect™ “Basic” Function “Quick” Reference

Solid Door Models:

Function		Function Access
Turn Unit On & Off	Pressing and holding the keypad OFFON for 5-seconds will turn the unit “ON” or “OFF”.
Adjust Temperature Set-Point	To adjust temperature set-point, touch SET keypad and current set-point will be displayed.
	Use the WARMER or	COLDER keypads to adjust set-point temperature.
Display “Actual” Temperature	Display represents “real-time” monitoring of the compartments stored wine and/or
	contents. Some temperature fluctuation around your desired set-point is normal.
Select ºF or ºC Display	Pressing the ˚̊F/C	keypad will toggle the display between Fahrenheit and Centigrade
	temperature display.
Black-Out Mode	Display automatically shuts off when door is closed.
Display Lighting	Display Lighting can be enabled with the door closed by pressing the LIGHT keypad.
Sabbath Mode	Press and hold the SET keypad while pressing the ˚̊F/C keypad four (4) times.
TruProtect™ System	System monitoring is automatically enabled unless system has been disabled. (See
	below.)
Door Ajar Alarm	N/A
High/Low Temp Alarm	Note: Alarm may occur when changing set-points in excess of 10ºF, and/or high usage,
	this is normal.
Power Failure Alarm	Note: Alarm will occur upon initial installation, since unit was run at factory to verify
	quality, this is normal.
Reset Alarms	Close door to reset Door Ajar alarm. Press OFFON keypad to reset all other alarms.
Disable/Enable TruProtect™	Press and hold the SET keypad for 5-seconds to “disable” or “enable” TruProtect™
	System.

Glass Door Models:

	55˚			TruProtect System
		WARMER	F/C	POWER FAILURE - Flashing Amber
ON		SET	˚̊
OFF				HIGH/LOW TEMP - Red
		COLDER	LIGHT
				ALARMS OFF - Steady Amber

PRESS AND HOLD PRESS ON/OFF - Reset

Control Confirmation/Comment

Display will be blank 38˚F when refrigeration sytem is off. Lights will still function, but will time-out 15 minutes after each activation, if door is left open or display lighting is on, to prevent overheating.

“Set” will appear in display 55˚F when in set-point mode. “SET” mode will automatically time-out in 10 seconds if no keypad activity occurs, or you may exit “SET” mode by pressing the SET keypad a second time.

Temperature variation in “compartment air”, above and below set-point, is a normal effect of refrigeration system cycling on and off. Stored items will not experience the full temperature swing of the compartment air due to the dampening effect of their thermal mass.

55˚F = 13˚C

In addition, the control panel is hidden when door is closed.

Option available on Glass Door Models only.

Display will flash SA seven (7) times, then unit will enter Sabbath Mode. The display, audible alarms, LED and lights will be disabled. Sabbath Mode will automatically time-out in 36 hours, or can be exited by repeating the enable keypad routine.

LED displays steady green

Audible alarm will sound 3-times every 30-seconds, LED will flash green.

Alarm will sound 6-times every minute and LED will flash red	if product temperature excursions occur for a duration
outside acceptable limits.

LED will flash amber whenever power is interrupted to unit. No audible signal.

Note that although pressing the OFFON keypad will reset the alarms, the alarm will resume if the “alarm condition” still exists.

LED displays steady green when alarms enabled. LED displays steady amber when disabled.

14 15