Viking BRTGK72SS installation instructions Refrigerator Installation con’t

REFRIGERATOR INSTALLATION (con’t)

Securing the refrigerators					24"
1.	Locate and predrill 1/4” (.6 cm) holes in the first					3”
	mounting board (supplied). Countersink the bolt			WALL BOARD
	heads into the 2 x 4 board using a 1-1/8” (2.9 cm)			OR PLASTER
	counterbore wood bit 1-1/4” (.6 cm) deep. Locate		2x4 MOUNTING
	and mark 2 wall studs to mount the first 2 x 4 board.	ACCESS TO	BOARDS
	Do not cover the electrical outlet (see “Site
	Preparations” on p. 3).	LAG BOLTS
2. Bolt anti-tip mounting board securely to wall studs.
3. Predrill 1/4” (.6 cm) in second mounting board
	(supplied). Countersink the bolt heads into the 2x4
	board using a 1-1/8” (2.9 cm) counterbore wood bit	OTE:
	1/4” (.6 cm) deep.	EFRIGERATOR IN A 24"
4.	Attach flush to first 2x4.	EEP OPENING WILL BE
		LUSH AT FRONT SURFACE.
	If application does not have studs, mount to the wall	SE 1-1/2" THICK MOUNTING
	using a minimum of four 1/4” (.6 cm) diameter	OARD. IF REFRIGERATOR
	fasteners (not supplied). If cabinets are deeper than	TO PROTRUDE BEYOND
		4", ADDITIONAL MOUNTING
	24”, mounting board must be shimmed. The shim OARD THICKNESS IS
	must be structurally secured to the mounting	EQUIRED.
	board.

WALL STUD

LAG BOLT WITH EXTENDED SHAFT

NOTE: THE SPACE BETWEEN THE REAR OF THE

REFRIGERATOR CABINET AND THE CONDENSING UNIT ASSEMBLY HOUSING IS 3” (7.6 CM) DEEP. ADDITIONAL MOUNTING BOARDS MAY BE REQUIRED IF THE UNIT DOES NOT TOUCH THE BACK WALL OF THE ENCLOSURE.

LEVELING WHEEL BOLTS

LEVELING FEET

5.To avoid water line damage, verify water line is secure so refrigerator does not run over the water line when moved into opening.

6.Repeat steps above for second refrigerator.

Before moving the refrigerators in place, confirm the finished dimensions, electrical, and plumbing locations, minimum door clearances, and door panel installations are accurate (see pages 2, 3, & 4).

7.Position refrigerators in front of cutout.

8.Remove the top air grille assemblies from both of the refrigerators. (See illustrations on page 7)

a.Remove the center grille blades by lifting up and pulling forward.

b.Remove the grille/end cap assembly by removing the four (4) screws in each black air duct.

c.Remove the black air ducts by removing the eight (8) screws on the right hinge model and the seven (7) screws on the left hinge model. Save the air ducts for the 72” grille installation.

9.Verify operation by plugging power cord. Power

switch will be shipped in the ON position and showroom switch will be in the ON position. (If showroom switch is switched to the “OFF” position, showroom mode is engaged and power is shut off to the compressor. This mode is for showroom display only.)

6