Invacare Powered Seating manual Installing the Battery Door and Rear Shroud, Installing Batteries

SECTION 10—ELEVATE BATTERIES

	REAR OF WHEELCHAIR
	Disconnect Batteries
	from Controller Here
NOTE: Battery
cables not shown for
clarity.	Rear Battery
	Battery Box
Left Battery	Right Battery
Connector	Connector
YELLOW Battery	BLACK Battery
Connector Tab	Connector Tab
	Front Battery

FRONT OF WHEELCHAIR

FIGURE 10.4 Installing Batteries

Installing the Battery Door and Rear Shroud

WARNING

Wheelchairs with TRRO or TRBKTS Only - Battery support brackets MUST be installed at all times. Otherwise, the wheelchair will not be WC/19 compliant.

After installing battery door, ensure that the mounting screws on the side of the battery door are fully engaged into the side of the battery box.

NOTE: For this procedure, refer to FIGURE 10.2 on page 67.

1.Wheelchairs with TRBKTS Only - Install the battery support bracket onto the battery box (Detail “B” of FIGURE 10.2 on page 67) using the four hex screws and four locknuts (if applicable). Torque to 75 in-lbs.

2.Reinstall battery door onto front of wheelchair.

3.Install both mounting screws on the side of the battery door.

NOTE: Ensure that the mounting screws on the side of the battery door are fully engaged into the side of the battery box.

WARNING

When installing batteries, ensure battery connector is securely engaged to the con- troller connector - otherwise serious personal injury may result.

Part No 1122170 69 Formula™ Powered Seating