SECTION
Height and Width Adjustment
1.Remove the two height/width adjustment screws securing the calf pad to the calf pad mounting bracket.
2.Move the calf pad to the desired position.
3.Install the two height/width adjustment screws to secure the calf pad to the calf pad mounting bracket.
4.Check operation of the calf pads to ensure there is no interference with the seat pan or the carriage assembly. If there is interference, readjust calf pad.
5.Repeat STEPS 1 to 4 for the opposite side, if desired.
Installing/Removing the Power Elevating Legrests
WARNING
To prevent personal injury, always verify proper positioning of legs and feet prior to use. Individual user weight may impact the rate of travel for each legrest assembly. If simultaneous operation is desired, select a speed which allows for the most uniform travel.
DO NOT insert fingers between legrest components, otherwise personal injury may occur.
CAUTION
Never allow items to become trapped between the legrest assemblies, otherwise damage to the power legrests may occur.
Ensure that all parts of both power legrests are clear of any obstructions before rais- ing and lowering, otherwise damage to the power legrests may occur.
NOTE: For this procedure, refer to FIGURE 6.22 on page 52.
NOTE: Power legrests are linked to the recline function of the powered seating system. Operating the recline function automatically operates power legs. Power legrests can also be operated independently of the recline function.
Installing the Power Elevating Legrests
1.Turn power legrest to side (open footplate is perpendicular to wheelchair) (Detail “A” of FIGURE 6.22).
2.Insert the mounting pin of power legrest into the mounting hole of the seat frame (Detail “A” of FIGURE 6.22).
NOTE: Make sure the legrest sits flush on the seat frame.
3. Rotate the power legs toward the INSIDE of the wheelchair until it locks in place.
NOTE: The footplate will be on the INSIDE of the wheelchair when locked in place.
4. Repeat STEPS
Part No 1122170 | 51 | Formula™ Powered Seating |
