SECTION 5—WHEELCHAIR OPERATION
Using the Powered Seating Switch
NOTE: The powered seating switch will alternate functions (increase tilt angle, decrease tilt angle) after it has been released for a minimum of three seconds.
1.Make sure the wheelchair is on a level surface.
2.Press the powered seating switch once to activate the actuator.
3.Press the powered seating switch again (after at least 3 seconds) to activate the actuator in the opposite direction.
Using the Four Way Switch
NOTE: For this procedure, refer to FIGURE 5.1 on page 26.
1.Make sure the wheelchair is on a level surface.
2.Refer to the chart for the operation of the seating system using a four way switch.
NOTE: The chart shows the factory programmed settings only. Switch assignments can be reprogrammed.
SEATING SYSTEM |
| FOUR WAY SWITCH |
| ||
|
|
|
| ||
FORWARD | REAR | LEFT | RIGHT | ||
| |||||
|
|
|
|
| |
Formula TRE - Tilt Only | Decrease the Tilt | Increase the Tilt | N/A | N/A | |
| Angle | Angle |
|
| |
|
|
|
|
| |
Formula TRE - Recline | Decrease the | Increase the Recline | Power Legrest Up/ | Power Legrest Up/ | |
Only | Recline Angle | Angle | Down* | Down* | |
|
|
|
|
| |
Formula TRE - Tilt/Recline | Decrease the | Increase the Recline | Decrease the Tilt | Increase the Tilt | |
| Recline Angle | Angle | Angle | Angle | |
|
|
|
|
| |
Formula TRE - Elevate | N/A | N/A | Elevate/Lower the | N/A | |
Only** |
|
| Seat* |
| |
|
|
|
|
| |
Formula TRE - Tilt/Elevate | Increase/Decrease | N/A | Elevate/Lower the | N/A | |
| the Tilt Angle* |
| Seat* |
| |
|
|
|
|
| |
Formula TRE - | Increase/Decrease | Increase/Decrease | Elevate/Lower the | Power Legrest Up/ | |
Tilt/Recline/Elevate | the Tilt Angle* | the Recline Angle* | Seat* | Down* | |
|
|
|
|
| |
*NOTE: The
**NOTE: The seat MUST be tilted/reclined so the back angle is less than 20° relative to the vertical position before elevating/lowering the seat.
NOTE: If the wheelchair is equipped with switch options, scan to the correct ECU or Auxiliary Mode and activate the control device in the corresponding "forward" direction to operate the tilt function. Refer to the electronics manual for complete switch option operating instructions.
3. Release four way switch to neutral position.
Part No 1122170 | 25 | Formula™ Powered Seating |
