Invacare Powered Seating manual Removing/Installing/Adjusting Headrest

SECTION 9—HEADREST

SECTION 9—HEADREST

WARNING

After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

CAUTION

If using a ventilator, verify headrest support does not interfere at ALL angles. Oth- erwise, injury or damage may occur.

Removing/Installing/Adjusting Headrest

NOTE: For this procedure, refer to FIGURE 9.1.

Removing

1.Loosen, but DO NOT remove, the thumb screw that secures the headrest to the headrest mounting bracket.

2.Remove the headrest from the headrest mounting bracket.

Installing

1.Make sure thumb screw is loose.

2.Install the headrest until the headrest stop sits on the headrest mounting bracket.

3.If necessary, adjust the height, depth or direction of the headrest. Refer to Adjusting Headrest Height on page 61 or Adjusting Headrest Depth/Direction on page 61.

Slide	Offset Fixture	Depth
Tube		Adjustment

Socket

Screws

Height

Adjustment	Set Screw
Thumb	Headrest
	Mounting
Screw
	Bracket
	Headrest Stop

FIGURE 9.1 Removing/Installing/Adjusting

Headrest

Formula™ Powered Seating 60 Part No 1122170