SECTION
Adjusting the Angle of the Manual Center Mount Footrest
WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is three inches. If the wheelchair is not moving, the front rigging MUST maintain a minimum of one inch ground clearance - otherwise personal injury and damage may result.
NOTE: For this procedure, refer to FIGURE 6.16 and FIGURE 6.17.
1.Engage the release lever with one hand (not shown) and move the center mount footrest to the desired angle with the other hand.
NOTE: Refer to FIGURE 6.16 for the location of the release lever.
2.Disengage the release lever (not shown) to lock the center mount footrest in the new position.
Adjusting the Footplate Angle
After 2/14/07
NOTE: For this procedure, refer to FIGURE 6.18.
1.Loosen, but DO NOT remove, the two rear mounting screws and side mounting screw.
2.Move the footplate to the desired angle.
3.Tighten the two rear mounting screws and side mounting screw to secure the footplate in the desired position.
4.Repeat STEPS 1 and 2 for the other footplate.
Center Mount
Front Rigging
Rear Mounting | Footplate |
Screws |
|
Side Mounting
Screw
FIGURE 6.18 Adjusting the Footplate
Angle - After 2/14/07
Formula™ Powered Seating | 48 | Part No 1122170 |
