SECTION 6—FRONT RIGGINGS

70° Taper

 

 

 

 

 

 

Footrest

 

 

 

 

 

 

NOTE: For this procedure, refer to

 

 

Mounting Pin

 

 

 

 

 

 

 

 

 

FIGURE 6.2

 

 

 

Footrest

1.

Turn the footrest to the side (open

 

 

 

Release

Mounting Tube

 

Lever

 

footplate is perpendicular to

 

 

 

 

 

 

 

wheelchair).

Footplate

 

 

2.

Insert footrest mounting pin into

 

 

 

 

 

mounting tube.

 

 

 

 

3.

Push the footrest towards the inside of

FIGURE 6.2 Installing/Removing Footrests -

 

the wheelchair until it locks into place.

 

 

70° Taper

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4.Repeat STEPS 1- 3 for the other footrest assembly.

5.To remove the footrest, push the footrest release lever inward, rotate footrest outward.

6.Adjust footrest height, if desired. Refer to Footrest Height Adjustment on page 36.

Footrest Height Adjustment

WARNING

Minimum ground clearance for the footrest is 3 inches - otherwise personal injury or damage may result.

PHAL4A Front Riggings

NOTE: For this procedure, refer to

FIGURE 6.3.

1.Loosen, but DO NOT remove, the lug bolt and locknut that secure the lower footrest to the footrest support.

2.Reposition the lower footrest to the desired height.

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1-3 for the opposite side of the wheelchair footrest, if necessary.

NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.

Footrest

SupportLocknut

Lower Footrest

Lug Bolt

FIGURE 6.3 Footrest Height Adjustment

Formula™ Powered Seating

36

Part No 1122170

Page 36
Image 36
Invacare Powered Seating manual Footrest Height Adjustment, Taper, PHAL4A Front Riggings